Proper maintenance is crucial for maximizing the performance and lifespan of your Chinacnczone handheld Continuous laser cleaning machine.
Here’s a concise guide based on the official manual:
🔧 Daily & Regular Maintenance
-
Cooling System Care
-
Coolant: Use purified water + 10% ethanol (by volume) to prevent mold. Replace monthly.
-
Low-Temperature Adjustment:
-
At -10°C to 0°C: Use 30% ethanol solution (replace every 2 months).
-
Below -10°C: Mandatory dual-system water chiller (with heating).
-
-
Water Temperature: Set to 25±1°C. Never operate if coolant is <20°C.
-
⚠️ Warning: Incorrect temperature causes irreversible laser damage!
-
-
Optical Components Maintenance
-
Cleaning Method:
-
Use dust-free gloves, isopropanol, and cotton swabs.
-
Wipe lenses unidirectionally (bottom→top or left→right).
-
Finish with dry, pure compressed air.
-
-
Replacement Tips:
-
Note lens orientation (convex/plane side) during disassembly.
-
Seal ports immediately with textured paper to block dust.
-
-
🛠️ Key Component Handling of Chinacnczone handheld Continuous laser cleaner.
*Tools needed: 2mm hex wrench, alcohol, dust-free swabs.*
| Component | Critical Steps |
|---|---|
| Collimating Lens | 1. Loosen M2.5 screws → Extract drawer module → Rotate gland counterclockwise → Replace lens (convex side up). |
| Focus Lens | 1. Remove lateral screws → Slide out assembly → Rotate gland → Replace (flat side down). |
| Protective Lens | 1. Pull drawer upward → Rotate gland → Replace (fastest swap). |
🚨 Troubleshooting Common Alarms of Chinacnczone handheld Continuous laser cleaning machine
| Alarm Type | Solution |
|---|---|
| Cool System Alarm | Check water level/flow → Refill if low → Restart. Persistent? Contact support. |
| Temperature Alarm | Verify chiller temp (10-28°C) → Ensure refrigeration works → Reboot. |
| Blowing Alarm | Confirm air pressure ≥0.1Mpa → Adjust regulator. |
| Lens Overheat | Set lens temp limit to 50°C (System Settings → Password: 666888). |
The Chinacnczone handheld Continuous laser cleaner as below for your reference
https://scotlelaser.com/collections/continuous-laser-clean-machine/products/bwt-1500w-2000w-3000w-laser-cleaning-machine-laser-rust-remove-oil-coating-paint
