This guide will walk you through the essential steps to power on and connect Chinacnczone Continuous handheld laser cleaner, ensuring a smooth and efficient cleaning process. Let's dive in!
1. Unboxing and Initial Inspection
Upon receiving your Chinacnczone handheld laser cleaning machine, carefully remove it from its packaging. Inspect the machine for any visible signs of damage or deformation. Ensure that all components are included as per the package contents list provided in the manual.
2. Filling the Water Tank
Before energizing the machine, fill the water tank with pure water. Use the water level gauge on the back of the machine as a guide, filling it until the water reaches the green mark. This step is crucial for the proper functioning of the cooling system.
3. Connecting the Power Cord
Next, connect the power cord to the electrical box of the machine. Ensure that the connection is secure to prevent any electrical issues during operation.
4. Connecting the Air Compressor
Attach the air compressor to the machine. The air compressor should have a flow rate of at least 15L/min to ensure optimal performance. Once connected, adjust the air pressure gauge on the back of the machine to 0.2-0.3Mpa using the knob provided.
5. Energizing the Machine
Now, it's time to power on the machine. Toggle the air switch on the back of the machine up, then flip the switch on the machine's control panel. The screen should light up, indicating that the machine is starting to run.
6. Pre-Operation Checks
Before starting the cleaning process, perform the following checks:
- Water Chiller Temperature: Ensure that the water chiller temperature is not lower than 20℃. If it is, wait for the machine to warm up to this temperature before proceeding.
- Alarm Check: Look for any alarm indicators flashing in the upper right corner of the panel. If there are no alarms, you can continue with the operation.
7. Adjusting Parameters
Adjust the cleaning parameters such as power and scan width according to your cleaning requirements. Select the appropriate power level, wobble type, and scan size for optimal results.
8. Activating the Laser
Click on the "READY TO CLEAN" button located at the bottom right corner of the screen to activate the laser. This will prepare the machine for the cleaning process.
9. Starting the Cleaning Process
Uncover the muzzle protector of the gun head and aim it at the material you wish to clean. Double-click the button on the gun head and hold it down to initiate the laser beam. Move the gun head steadily across the surface to remove dirt, rust, or coatings effectively.
10. Post-Operation Care
After completing the cleaning process, ensure that you:
- Turn Off the Machine: Safely shut down the machine by following the correct shutdown procedure outlined in the manual.
- Clean the Equipment: Wipe down the surface of the equipment to remove any dust or debris accumulated during operation.
- Inspect the Cooling System: Regularly check the coolant level and the operation of the cooling system to ensure its longevity and efficiency.
The Chinacnzone Continuous Handheld Laser Cleaning machine product link as below
https://scotlelaser.com/collections/continuous-laser-clean-machine/products/bwt-1500w-2000w-3000w-laser-cleaning-machine-laser-rust-remove-oil-coating-paint
